Shanker Industries has been manufacturing
Authentic Decorative Metal Walls & Ceilings since 1896. Using original
sand casted steel dies. Our massive Bliss Power Press insures a clean
clear and uniform stamp every time. Over 40 patterns & 18 cornices
designs to choose from. Finishes available are Steel, Brass, Copper,
Chrome, White and Stainless Steel.
Painting
Shanker Industries products are
manufactured from 30 gauge (.010) tin-free steel, which is chromium
treated for good paint retention. Although a primer is not required
for most environments, we recommend its application prior to painting
in places exposed to heat, humidity, condensation or other moisture
where corrosion may be a concern. If painted properly using a high gloss
or semi gloss oil based paint, or a clear gloss polyurethane to finish
the product in its natural state, the panels can easily last a lifetime.
Water based or latex paints cannot be used, as they will induce corrosion.
- Go to
Top -
Prefinished Panels
Shanker Industries can have the panels painted prior to shipment
at an additional charge (depending on quantity) on a special order basis.
We work with a metal-powder coating paint line, which gives a tough
resilient finish. This can hold labor costs down when the area to paint
is rather large. In many cases, particularly small installations of
200 sq.ft. or less, on-site painting is usually more economical.
We also produce all ceiling panels in brass, copper,
chrome, or prepainted white. These panels are shipped with a baked on
clear enamel, as well as a PVC peel-off film, to protect the finish
in transit and during installation.
- Go to
Top -
Acoustics
Our ceiling panels are made of steel and do not absorb sound.
We have found few complaints about noise levels, particularly if there
is other sound absorbing material in the room such as carpeting, wall
coverings or drapery. In fact, many restaurants, particularly those
that cater to younger crowds actually prefer a higher noise level. However,
where acoustics are important, all our patterns are available in perforated
metal, where much of the sound can pass through the panel into the materials
behind it.
Maintenance & Cleaning
When properly coated, no maintenance
is required. We do recommend the use of semi-gloss finishes, as these
can be cleaned easily with a mild soap and water.
- Go to
Top -
Ordering Information
All patterns are usually in stock and available for shipment
within 3-5 business days after on order is place. However, you should
check with our office for information and lead times on perforated panels,
pre-painted panels, brass or copper panels, 2' X 2' lay in panels (usually
cut to order) or any quantities of 500 or more. We will do everything
within our power to ensure prompt delivery of your order.
Small orders of 2'X2's , 2'x4's and cornice can be
shipped UPS. All other orders, including all 2'X8's are shipped common
carrier, freight F.O.B. New Jersey.
